Video 5.4 – Conquer Radio Frequency


#Ipage offers the worst service and tech support – I can’t begin to tell you of my frustration with #Ipage. First off, they measure their wait time for tech support in DAYS not minutes. You will wait forever. I assume they have only one tech support person for the entire planet! Setting up email accounts was a nightmare! In short, I was burned! If something looks too good to be true, it probably is and that’s very true in the case of #Ipage. Would not recommend it to anyone. Thomas, Montreal, QC


Amplifier Stability Part 2.
Stabilisation though reactive emitter degeneration. Demonstration of its validity at frequency of interest and higher frequencies.
Analysis of stability at lower frequencies when this technique is used. Demonstration of need for stabilisation at frequencies lower than operating frequency.
Mu factor versus frequency for reactive stabilisation and purely resistive stabilisation.
Comparison of broadband performance and identification of improvements needed in purely resistive stabilisation which result in further loss of gain.

Version 13 update: In version 13, “To” and “From” ports must now be specified for a number of two-port measurements. This was not required for version 12 or earlier.
The measurement “MU1()” shown in the video has now been replaced by MU1(2,1) in version 13. That is “To port”=2, “From port”=1.
“MU2()” has also been replaced by MU2(2,1).
The measurement “SCIR1()” shown in the video has now been replaced by SCIR1(2,1) in version 13. “SCIR2()” has also been replaced by SCIR2(2,1).

You may download the “Conquer Radio Frequency” e-book, which provides support materials for these videos, at http://explorerf.ipage.com/conquer_radio_frequency_ebook.pdf

Explore RF

No Comments

Sorry, the comment form is closed at this time.